Show simple item record

dc.contributor.authorGlover, James
dc.date.accessioned2017-02-16T09:53:56Z
dc.date.available2017-02-16T09:53:56Z
dc.date.issued2016-09
dc.identifier.urihttp://hdl.handle.net/2086/13299
dc.description.abstractModern high frequency electronic devices are continually becoming smaller in area but capable of generating higher RF power, thereby increasing the dissipated power density. For many microwave devices, for example the planar Gunn diode, standard thermal management may no longer be sufficient to effectively remove the increasing dissipated power. The work has looked at the design and development of an active micro-cooler, which could be fully integrated with the planar Gunn diode at wafer level as a monolithic microwave integrated circuit (MMIC). The work also resulted in the further development of novel thermal measurement techniques, using micro-particle sensors with infra-red (IR) thermal microscopy and for the first time to measure thermal profiles along the channel of the planar Gunn diode. To integrate the gallium arsenide (GaAs) based planar Gunn diode and micro-cooler, it was first necessary to design and fabricate individual GaAs based planar Gunn diodes and micro-coolers for thermal and electrical characterisation. To obtain very small area micro-coolers, superlattice structures were investigated to improve the ratio between the electrical and thermal conductivities of the micro-cooler. To measure the specific contact resistivity of the superlattice based micro-cooler contacts, the Reeves & Harrison TLM (transmission line method) was used as it included both horizontal and vertical components of the contact resistance. It was found, for the GaAs based micro-cooler, only small amounts of cooling (<0.4 ºC) could be obtained, therefore the novel temperature measurement method using micro-particle sensors placed on both the anode and cathode contacts was utilised. The bias probes used to supply DC power to the micro-coolers were found to thermally load these very small structures, which led to anomalously high measured cooling temperatures of >1 ºC. A novel approach of determining if the measured cooling temperature was due to cooling or probe loading was developed. A 1D model for the integrated micro-cooler was developed and the results indicated that when the micro-cooler was used as a cooling element in a monolithic microwave integrated circuit, the supporting substrate thickness was very important. Simulation showed to obtain cooling the substrate thickness had to be very thin (<50 μm), which may preclude the use of GaAs micro-coolers as part of a monolithic microwave integrated circuit.en
dc.description.sponsorshipEPSRCen
dc.language.isoenen
dc.publisherDe Montfort Universityen
dc.subjectthermal measurementen
dc.subjectthermal managementen
dc.subjectplanar Gunn diodeen
dc.subjectthermoelectric,en
dc.subjectmicro-cooleren
dc.titleThe design and thermal measurement of III-V integrated micro-coolers for thermal management of microwave devicesen
dc.typeThesis or dissertationen
dc.identifier.grantnumberEP/H011366/1en
dc.publisher.departmentFaculty of Technologyen
dc.publisher.departmentSchool of Engineering and Sustainable Developmenten
dc.type.qualificationlevelDoctoralen
dc.type.qualificationnamePhDen


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record